Configure MLD Version

About this task

Use this procedure to configure MLD version.

Procedure

  1. Enter Interface Configuration mode:

    enable

    configure terminal

    interface GigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]} or interface vlan <1–4059>

    Note

    Note

    If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

  2. Configure MLD version:
    ipv6 mld version <1-2>
    Note

    Note

    For MLD to function correctly, the MLD version must be the same on all routers in the network.

Variable Definitions

The following table describes the variables for the ipv6 mld version command.

Variable

Value

<1–2>

Indicates the version of MLD that runs on this interface.
9039040-00 Rev AB